Winch Accessories

Features:
12 ft. lead remote control
All hoses and fittings included
Power in and power out
Remote Solenoid-activated control valve draws only 2 amps
Uses existing power steering pump as hydraulic power source

To be used with 75-Series Winches

This magnetic filter provides dual filtration that is designed to be completely effective in removing ferrous metal particles from power steering lubricating systems. The filter attracts the ferrous particles down to a sub-micron level.

The secondary paper filtration media removes the non-ferrous material. The Filter provides full line flow capabilities for power steering systems, and incorporates a pressure by-pass relief valve.

This is a high output power steering pump. This pump is a perfect match for Milemarker winches, 1500 PSI and 3.5 GPM.

Works excellent as a dedicated pump just for the winch. The shaft diameter is .750 inch.

4WD-TO-2WD Conversion Kit with Hubs

Reduces power loss and wear and tear on the driveline
Saves fuel—go further on a tank of gas
For '73-79 full-time 4WDs with new process 203 transfer case

Easy to install using common hand tools. Normal high and low range selection not affected. Use stock lever to select 2WD or 4WD—no extra lever needed. No need to remove transfer case. Kit includes coupling gears, 2 all-metal MileMarker® locking hubs, bearings, washers, gasket and instructions.

Features:

Includes snatch block, tree trunk protector, shackle, gloves and choker chain.
Compact, Codura nylon soft case with internal pockets.
The tow strap is 15' long and rated at 30,000 lbs.

 

Features:
This kit will enable you to put the MileMarker Winch on a quick disconnect system for the front amd rear mount if the winch is to be installed on a receiver type hookup.

Rear Mount Quick Disconnect Kit also includes foot hoses and adapters.

Features:
Snatch Block: 24,000 lb. Rating.
Uses grease fitting to provide less friction on pulley rotation

This multi-purpose snatch block can double the pulling power of any winch, or change your pulling direction without damaging the wire rope.

Can be used with MileMarker, Warn, Ramsey or Superwinch Winches. Also fits all winch Mount Bumpers.